The watch is equipped with energy-saving Bluetooth® technology, which offers power-saving data transfer at the push of a button. The watch can connect to a smartphone wirelessly via Bluetooth®, enabling access to a wide range of useful functions.
Local time will automatically be adjusted whenever the watch is connected with a smartphone.
Thanks to the GPS receiver, the watch always displays the GPS-accurate time no matter where you are in the world.
Full-Auto LED light
A twist of the wrist in weak light conditions automatically lights up the display backlight.
Shock-resistant construction protects against impact and vibration.
Optical heart rate monitoring
An optical sensor on the back of the watch case measures the heart rate on the wrist using light-emitting diodes (LEDs). The measured values are displayed on the watch.
The motion sensor responds to acceleration and shows this as a speed on the display.
The watch has a built-in 3-axis accelerometer that counts the steps you take and indicates the numbers on the display.
GPS speed-distance measurement
High-tech for demanding runners: The watch uses GPS technology to measure the current running speed and distance covered. All data are individually indicated on the display.
Barometer (260 / 1.100 hPa)
A special sensor measures the air pressure (measuring range: 260 / 1100 hPa) and presents this on the display in the form of a symbol. This enables early detection of weather trends.
10,000 m Altimeter
A pressure sensor detects changes in the air pressure and converts the result into an altitude up to 10,000 m.
The Training Planner supports your personal training goals and gives a signal by reaching predefined targets. For example, a specific calorie consumption or a certain work out time can be set in advance in order to control the workout individually.
VO2max recovery time
Good training needs regeneration. In order to make the training as effective as possible, there is the display for the VO2max recovery time, which shows the recovery time required until your body has recovered from the previous training. Then the next session can start.
This function shows training status, fitness level and training load as well as regeneration times. This information provides a good basis for planning further training sessions.
A training log stores the number of steps, calorie consumption as well as distance and lap times and helps to compare training units.
World time function
Displays the current time in major cities and specific areas around the world.
Stopwatch function - 100 hours
Measures with an accuracy of seconds the meantime and the end time. Signals confirm the starting/stop selection. The measuring capacity reaches up to 100 hours.
Lap memory 100
Measured total, lap and split times can be stored in a memory with the date and can be displayed again later. A data set consists of: date, total, lap and split times. The memory has enough space for up to 100 data sets.
5 Timer - 1/1 Sec. - 60 Min. (with automatic repeat)
The count-down timer gives a signal by reaching the set time. The measuring capacity reaches up to 60 minutes. The timer can count back automatically again from the preset time. Five of these countdown alarms can be set independently.
4 daily alarms
The daily alarm reminds you about recurring events with an acoustic signal at the time you have set. This model has four independent alarms for flexible reminders of important appointments.
Each time you stop the alarm, it sounds again after a few minutes.
The vibration alarm discreetly reminds you of important appointments, without emitting a loud signal.
Button tones on/off
The button tones for using the mode button can be turned off. This means that the watch no longer beeps when switching from one function to another. Preset alarm or countdown timers remain active when the button tones are deactivated.
Misplaced your smartphone? All it takes is the push of a button on your watch and the smartphone sounds an alarm.
Airplane Mode (Offline Mode)
At the touch of a button, the watch switches to offline mode. This means that you can disable the wireless or GPS receiver when in the air for the duration of the flight.
The resin housing is the ideal everyday companion. It is durable, lightweight and relatively insensitive to cold, heat or other external influences.
Synthetic resin is the ideal material for wrist straps thanks to its extremely durable and flexible properties.
The bracelet is equipped with a buckle.
Charging option via clip and USB charging cable.
63,0 mm x 55,0 mm x 20,4 mm (H x W x D)